Proxim ORiNOCO AP-8000 Guía de usuario Pagina 134

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 169
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 133
Using CLI to Manage the Access Point AP-8000 User Guide
Managing the Device Using CLI Commands
134
(config-mgmt-telnet)#password public
Device-Name# show management http
// RUNNING-CONFIGURATION //
// Telnet Configuration //
telnet {
password: ******
}
SNMP Read, Read Write Password and Trap Host Table Configuration
You can change the SNMP passwords using the following commands. To add an entry and enable the AP to send SNMP
trap messages to a Trap Host, specify the IP Address and Password for the Trap Host.
# configure
(config)# dev-management
(config-mgmt)# snmp
(config-mgmt-snmp)# read-password public
(config-mgmt-snmp)# read-write-password public
(config-mgmt-snmp)# trap-host-table
(config-mgmt-snmp-trap<tble>)# index 1 ipaddress 192.168.1.1
(config-mgmt-snmp-trap<tble>)# index 1 password public
Device-Name# show management snmp read-password
// RUNNING-CONFIGURATION //
// SNMP Configuration //
snmp {
read-password: ******
}
Device-Name# show management snmp read-write-password
// RUNNING-CONFIGURATION //
// SNMP Configuration //
snmp {
read-write-password: ******
}
Device-Name# show management snmp trap-host-table
// RUNNING-CONFIGURATION //
// SNMP Trap Host Table //
index 1 {
ip-address: 169.254.128.133
password: ******
}
System Information Configuration
Perform the following to configure the System Information entries.
# configure
(config)# dev-management
(config-mgmt)# system
(config-mgmt-sys)# system-information
(config-mgmt-sys-sysinfo)# ?
Vista de pagina 133
1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 168 169

Comentarios a estos manuales

Sin comentarios