Proxim ORiNOCO AP-8000 Guía de usuario Pagina 125

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 169
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 124
Using CLI to Manage the Access Point AP-8000 User Guide
Configuring the Device Using CLI Commands
125
profile-name: WPA-WPA2
authentication-mode: dot1x
wep-key-index: 0
wepkey: ******
wepkeylength: wep64
encryption-type: wpa-wpa2aes-tkip
psk: ******
rekeyinterval: 900
entry-status: active
}
Filtering Configuration
The Access Point’s Packet Filtering features help control the amount of traffic exchanged between the wired and wireless
networks. There are four sub-tabs under the Filtering heading.
Advanced Filtering Configuration
The following protocols are listed in the Advanced Filter Table
Deny IPX RIP
Deny IPX SAP
Deny IPX LSP
Deny IP Broadcasts
Deny IP Multicasts
The AP can filter these protocols in the wireless-to-Ethernet direction, the Ethernet-to-wireless direction, or in both
directions.
You can configure the following advanced filtering options:
# configure
(config)# dev-configure
(config-dev<config>-filter-advanced)# index 1 protocol-name Deny IPX RIP
(config-dev<config>-filter-advanced)# index 1 direction both
(config-dev<config>-filter-advanced)# index 1 row-status notInSevice
Show command for Advanced Filtering Configuration
Device-Name # show configure filtering advanced-filter-table
// RUNNING-CONFIGURATION //
// Advanced Filter Table //
index 1 {
protocol-name: Deny IPX RIP
direction: both
row-status: notInService
}
index 2 {
protocol-name: Deny IPX SAP
direction: both
row-status: notInService
}
index 3 {
protocol-name: Deny IPX LSP
direction: both
row-status: notInService
}
index 4 {
Vista de pagina 124
1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 168 169

Comentarios a estos manuales

Sin comentarios