Proxim ORiNOCO AP-8000 Guía de usuario Pagina 131

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 169
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 130
Using CLI to Manage the Access Point AP-8000 User Guide
Configuring the Device Using CLI Commands
131
row-status: notInService
}
index 4 {
protocol-name: SNMP service
port-number: 161
port-type: both
interface: allInterfaces
row-status: notInService
}
index 5 {
protocol-name: IPSEC/ISAKMP
port-number: 500
port-type: both
interface: allInterfaces
row-status: notInService
}
index 6 {
protocol-name: L2TP
port-number: 1701
port-type: both
interface: allInterfaces
row-status: notInService
}
index 7 {
protocol-name: PPTP
port-number: 1723
port-type: both
interface: allInterfaces
row-status: notInService
}
Ethernet Configuration
Device-Name# show configure interface ethernet
// RUNNING-CONFIGURATION //
// Ethernet Interface //
ethernet {
mac-address: 00:20:a6:b0:aa:a1
speed: oneGBit
transmit-mode: fullDuplex
}
Vlan Configuration
VLANs are very useful to segment the LAN into different broadcast domains. This helps in reducing the broadcast
domain by separating logical segments of a LAN. VLANs can operate in different modes based on the incoming traffic.
Perform the following commands to configure the VLAN parameters.
# configure
(config)# dev-configure
(config-dev<config>)# vlan
(config-dev<config>-vlan)# status enable
(config-dev<config>-vlan)# vlan-id -1
Device-Name# show configure vlan
// RUNNING-CONFIGURATION //
// VLAN Configuration //
Vista de pagina 130
1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 168 169

Comentarios a estos manuales

Sin comentarios