Proxim ORiNOCO AP-700 Manual de usuario descargar pdf (Pagina 87)

Performing Advanced Configuration AP-700 User Guide

Radius Profiles

Figure 4-34 Add RADIUS Server Profile

• Server Profile Name: the profile name. This is the name used to associated a VLAN to the profile. Refer to Configuring Security

Profiles. The Server Profile Name is also used in the Configure > Management > Services page to specify the RADIUS profile to be

used for RADIUS Based Management Access.

• MAC Address Format Type: This parameter should correspond to the format in which the clients’ 12-digit MAC addresses are listed

within the RADIUS server. Available options are:

— Dash delimited: dash between each pair of digits: xx-yy-zz-aa-bb-cc

— Colon delimited: colon between each pair of digits: xx:yy:zz:aa:bb:cc

— Single dash delimited: dash between the sixth and seventh digits: xxyyzz-aabbcc

— No delimiters: No characters or spaces between pairs of hexidecimal digits: xxyyzzaabbcc

• Accounting update interval: Enter the time interval (in minutes) for sending Accounting Update messages to the RADIUS server. A

value of 0 (default) means that the AP will not send Accounting Update messages.

• Accounting inactivity timer: Enter the accounting inactivity timer. This parameter supports a value from 1-60 minutes. The default is

5 minutes.

• Authorization lifetime: Enter the time, in seconds, each client session may be active before being automatically re-authenticated.

This parameter supports a value between 900 and 43200 seconds. The default is disabled.

• Server Addressing Format: select IP Address or Name. If you want to identify RADIUS servers by name, you must configure the AP

as a DNS Client. See DNS Clientfor details.

• Server Name/IP Address: Enter the server’s name or IP address.

• Destination Port: Enter the port number which the AP and the server will use to communicate. By default, RADIUS servers

communicate on port 1812.

• Server VLAN ID: Indicates the VLAN that uses this RADIUS server profile. If VLAN is disabled, the text “VLAN is disabled” will

appear.

• Shared Secret and Confirm Shared Secret: Enter the password shared by the RADIUS server and the AP. The same password

must also be configured on the RADIUS server.

• Response Time (seconds): Enter the maximum time, in seconds, that the AP should wait for the RADIUS server to respond to a

request. The range is 1-10 seconds; the default is 3 seconds.

• Maximum Retransmissions (0-4): Enter the maximum number of times an authentication request may be transmitted. The range is

0 to 4, the default is 3.

• Server Status: Select Enable from the drop-down box to enable the RADIUS Server Profile.

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 241 242

Sin comentarios

Proxim ORiNOCO AP-700 Manual de usuario Pagina 87