
Using the Command Line Interface (CLI) AP-700 User Guide
Parameter Tables
161
DHCP Relay Server Table
The DHCP Relay Server Table contains the commands to set the table entries. The AP supports the configuration of a maximum of 10 server
settings in the DHCP Relay Agents server table.
Link Integrity Parameters
Link Integrity IP Target Table
Name Type Values Access CLI Parameter
DHCP Relay Server Table Table N/A R dhcprelaytbl
DHCP Relay Server Table Entry
Index
Integer32 1...10 R dhcprlyindex
DHCP Relay Server Table Entry
IP Address
IpAddress User Defined RW dhcprlyipaddr
DHCP Relay Server Table Entry
Comment
DisplayString User Defined RW dhcprlycmt
DHCP Relay Server Table Entry
Status
Integer Enable (1)
Disable (2)
Delete (3)
Create (4)
RW dhcprlystatus
Name Type Values Access CLI Parameter
Link Integrity Group N/A R linkint
Link Integrity Status Integer enable
disable (default)
RW linkintstatus
Link Integrity Poll
Interval
Integer 500 - 15000 ms
(in increments of 500ms)
500 ms (default)
RW linkintpollint
Link Integrity Poll
Retransmissions
Integer 0 - 255
5 (default)
RW linkintpollretx
Name Type Values Access CLI Parameter
Link Integrity IP Target
Table
Table N/A R linkinttbl
Table Index Integer 1-5 N/A index
Target IP Address IpAddress User Defined RW ipaddr
Comment (optional) DisplayString User Defined (up to 254
characters)
RW cmt
Status (optional) Integer enable
disable (default)
delete
RW status
Comentarios a estos manuales