Proxim RangeLAN2 7921 Manual de instrucciones Pagina 177
- Pagina / 333
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
System Utilities 6-5
2325A137REFGD Revision B 2325 Reference Guide
FLASHDSK.SYS
This driver configures all of the unit’s available flash memory as a read-
write disk, called a flash disk. Reading from a flash disk is fast, but
writing can be somewhat slower. This driver is located on the B drive
and is loaded by the CONFIG.SYS file located on that drive. You cannot
eliminate the loading of FLASHDSK.SYS.
FORMAT.COM
This utility formats a read-write disk drive. Only the flash and RAM
drives may be formatted using this command. FORMAT.COM uses the
existing drive parameters to recreate the drive, but without any files
stored on it. This provides a quick method for cleaning out an existing
drive.
Syntax
FORMAT [drive:] [/y]
Options
drive
Specifies the letter of the drive to be formatted. If you do not specify a
drive letter, the current drive is used.
/y
Suppresses output from being sent to the display, and bypasses the usual
prompt to proceed with formatting.
- Reference Guide 1
- Revision Notice 3
- 2325 Reference Guide 3
- Table of Contents iii 7
- Table of Contents v 9
- Table of Contents 13
- Chapter 1 15
- Document Conventions 16
- Technical Specifications 17
- Keyboard 18
- Display 18
- Battery 19
- Power Management 20
- Laser Module 21
- Radio PC Card 22
- PC Card 23
- Serial/Accessory 24
- Contacting LXE 25
- LXE Repair Services 26
- 125 Technology Parkway 26
- Norcross, GA 30092 26
- Manuals and Accessories 27
- Chapter 2 33
- Using Advanced Features 33
- Resetting the 2325 35
- Safe Boot 36
- Hardware Reset 37
- Using PC Cards 38
- Inserting a PC Card 39
- Radio Card Antenna Connector 41
- Radio Card Antenna Ports 41
- Removing a PC Card 42
- The Serial Port 43
- The Scanner Port 43
- The Antenna 44
- The Disk Drives 45
- Configuring the 2325 46
- Transferring Files 47
- Advanced Power Management 50
- Radio PC Card Configuration 52
- ODI with TCP/IP 53
- ODI with NetWare 55
- ODI With IPX/SPX 57
- Installing NDIS Drivers 59
- Link Support Layer 62
- TCPIP Protocol 62
- Install Proxim 62
- RangeLAN2 Drivers 62
- DOS Configuration 63
- Parameters 63
- Setting the RangeLAN2 65
- Security ID 65
- Install Lucent 66
- WaveLAN II Drivers 66
- NET.CFG File and 67
- MU Access Control 70
- Message Filtering 70
- Site Survey 71
- Throughput and Performance 72
- Operational Problems 72
- Problems with DOS Drivers 74
- Chapter 3 79
- Software Configuration 79
- Disk Drives and Files 80
- Drive A 81
- Drive B 83
- Drive C 86
- PCM Directory Files 87
- Drive D 88
- Drive E 88
- System Configurations 89
- Data Entry 92
- Terminal Emulation 93
- DOS Terminal 94
- Emulation User 94
- Defined Stored Forms 94
- 4-ii Table of Contents 96
- Chapter 4 99
- The Configuration Utility 99
- BIOS Upgrade File Location 100
- RF Files Location 100
- Quick Start 103
- The Main Menu 105
- Default 107
- Configuration File 108
- Settings File 109
- Configuration 111
- Settings 112
- First File 113
- Configuration Window 113
- Main Application 114
- Application Files 114
- Second File 117
- ATA Memory Cards 117
- I/O Cards 117
- Vendor Specific 118
- DOS Files 118
- Third File 121
- Text File 122
- The Program Settings Windows 123
- First Program 125
- Settings Window 125
- (Default.PRS) 125
- Second Program 126
- Third Program 127
- Fourth Program 128
- Fifth Program 129
- Last Program Settings 130
- Window (Default.PRS) 130
- The Comm Settings Dialog Box 131
- The File Transfer Window 132
- Files to Transfer 134
- Receive 136
- XFER 5-1 139
- Chapter 5 141
- Using XFER 141
- Introduction 141
- About XFER 141
- Syntax and Parameters 142
- Mcommand 151
- Multiple-Option Blocks 162
- Keywords 164
- DIAL_METHOD 165
- FAIL_STRINGS 165
- HANDSHAKING 165
- INIT_STRING 166
- LOCKED_BAUDRATE 166
- NUMBER# 166
- PROTOCOL_STRINGS 167
- Performance 169
- Error Codes 170
- Chapter 6 173
- Commands 173
- System Utilities 173
- CFGDEV.SYS 174
- CFGIO.EXE 175
- COMIO.COM 176
- DECODE.SYS 176
- FLASHDSK.SYS 177
- FORMAT.COM 177
- LOCK.COM 178
- ORGANIZE.COM 179
- VDISK.SYS 180
- XFER.EXE 180
- ROM-DOS Commands 181
- ATTRIB.EXE 183
- BUFFERS 184
- CHKDSK.EXE 185
- COMMAND.COM 187
- FIND.EXE 192
- HELP.COM 194
- NEWFILE 194
- PRINT.EXE 196
- SHARE.EXE 197
- SWITCHES 199
- TREE.COM 200
- XCOPY.EXE 202
- Illustrations 206
- Chapter 7 207
- The Docking Stations 207
- The Single Dock 208
- The Power Adapter 209
- Using a Single Dock 210
- Power Supply 211
- The Four Slot Dock 212
- Back Panel 213
- Creating a Dock Network 214
- Installation 215
- Using the 4-Slot Dock 216
- Operating Modes 216
- The 4SLOT.SYS Device Driver 217
- Transferring Files with XFER 218
- Setting the Baud Rate 219
- Using the DC Single Dock 222
- Before Installation 223
- Begins . . 223
- Vehicle 12VDC 224
- Connection 224
- Fuse Replacement 225
- LXE Vehicle Bracket 225
- Custom Mounting 228
- Brackets 228
- Vehicle Mount Dock 230
- Mounting to a Vehicle 231
- Using the Vehicle Mount Dock 231
- Appendix A 235
- Connector Configurations 235
- The 2325 Computer 236
- Serial Port Jack 237
- Single Dock 238
- 25-Pin Connector 239
- The 4-Slot Dock 241
- Host-Interface Cable 242
- Dock-Network Cable Jacks 243
- Appendix B 247
- Programming Parameters 247
- Code 39 248
- Interleaved 2 of 5 249
- Matrix 2 of 5 249
- Standard 2 of 5 250
- Code 11 250
- Codabar/Ames 251
- Code 93 252
- Numbering (JAN) 253
- UPC, EAN, JAN Extensions 254
- Code 128 254
- Labelcode 4/5 254
- Other Controls 255
- 2325 C-1 259
- C-ii Table of Contents 260
- Table of Contents C-iii 261
- C-iv Table of Contents 262
- Appendix C 263
- Barcodes for Configuring 2325 263
- Default Settings 264
- Barcodes 267
- Maximum Length 268
- Enable Checksum 269
- Send Checksum 270
- Full ASCII Mode - On 270
- Use Lengths 6 and 274
- 14 Only (Case Code) 274
- *$+$-141EE* 278
- *$+$-140EE* 278
- Use 2-Bar Start/Stop 282
- Enable - Off 283
- Minimum Length - 4 283
- Require 2 Check 285
- Digits - Off 285
- *$+$-1F1EE* 286
- *$+$-1F0EE* 286
- Send Stop/Start - Off 290
- Codabar-to-CLSI 291
- Conversion - Off 291
- Wide Intercharacter 291
- Gaps Allowed - On 291
- Check Digit Mod 295
- 11 - Off 295
- Send Check Digit(s) 295
- Minimum Length - 2 296
- C-36 Barcodes 298
- Enable UCC/EAN 128 301
- Enable UPC-A - On 303
- Send System Digit 303
- Send Check Digit 304
- Convert UPC-A to 304
- EAN-13 - Off 304
- Use System Digit 0 305
- Use System Digit 1 305
- Convert UPC-E to 306
- UPC-A - Off 306
- *$+$-381EE* 307
- UPC-E Send Check Digit On 307
- *$+$-380EE* 307
- UPC-E Send Check Digit Off 307
- Enable EAN-8/JAN-8 308
- Enable EAN-13/JAN 308
- Convert EAN-13 to 309
- ISBN - Off 309
- Send EAN/JAN 309
- Checksum - Off 309
- UPC/EAN/JAN Extensions 310
- *$+$-3E1EE* 311
- *$+$-3E0EE* 311
- Auto-Off Timer - 5 313
- Send Symbology 314
- Identifier - Off 314
- Good-Read Beep 315
- Tone (in Hertz) 315
- Number of Good 316
- Read Beeps - 1 316
- Duration (in 317
- Beeper Volume 318
- Error Beep Tone (in 319
- Hertz) - 2580 319
- *$+$-D41EE* 320
- Long Range Trigger Mode On 320
- *$+$-D40EE* 320
- Long Range Trigger Mode Off 320
- Spot Beam Timeout 321
- (in seconds) 0.5 321
- Release Scan 322
- Timeout (in seconds) 322
- Spotting Beam 323
- Enable - On 323
- Keypress Sound 323
- Enable Ctl-Alt-Del 324
- Reboot - On 324
- Enable Trigger 324
- Programmability 324
- Backlight Auto-Off 325
- *$+$-E220EE* 326
- *$+$-E230EE* 326
- Regulatory Notices 328
- An EMS Technologies Company 330
© 2020, manymanuals.es. Todos los derechos reservados | 0.155 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales