Proxim ORiNOCO AP-700 Manual de usuario Pagina 40

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 221
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 39
Advanced Configuration AP-700 User Guide
Network
40
Figure 4-4 DHCP Server Configuration Screen
You can configure and view the following parameters within the DHCP Server Configuration screen:
NOTE: You must reboot the Access Point before changes to any of these DHCP server parameters take effect.
Enable DHCP Server: Place a check mark in the box provided to enable DHCP Server functionality.
NOTE: You cannot enable the DHCP Server functionality unless there is at least one IP Pool Table Entry configured.
Subnet Mask: This field is read-only and reports the Access Point’s current subnet mask. DHCP clients that receive
dynamic addresses from the AP will be assigned this same subnet mask.
Gateway IP Address: The AP will assign the specified address to its DHCP clients.
Primary DNS IP Address: The AP will assign the specified address to its DHCP clients.
Secondary DNS IP Address: The AP will assign the specified address to its DHCP clients.
Number of IP Pool Table Entries: This is a read-only field that reports the number of entries in the IP Pool Table.
IP Pool Table Entry: This entry specifies a range of IP addresses that the AP can assign to its wireless clients. Click
Add to create a new entry. Click Edit to change an existing entry. Each entry contains the following field:
Start IP Address
End IP Address
Default Lease Time (optional): The default time value for clients to retain the assigned IP address. DHCP
automatically renews IP Addresses without client notification. This parameter supports a range between 0 and
86400 seconds. The default is 86400 seconds.
Maximum Lease Time (optional): The maximum time value for clients to retain the assigned IP address. DHCP
automatically renews IP Addresses without client notification. This parameter supports a range between 0 and
86400 seconds. The default is 86400 seconds.
Comment (optional)
Vista de pagina 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 220 221

Comentarios a estos manuales

Sin comentarios