Proxim 7910 Guía de usuario descargar pdf (Pagina 28)

To reset the unit back to the default setting, manually set the

Destination Address to 0.0.0.0 or reset the unit to factory de-

faults from within the software configuration menu.

When using this feature, have only two Serial Adapters config-

ured to Domain 8 on the rotary switch at any point in time. If

only one unit is configured for Domain 8, the Pairing Domain

will not change the unit’s configuration. If three Serial Adapters

are set to Domain 8 and then powered on, the outcome will be

unpredictable and may not result in a successful pairing of two

of the units.

The Pairing Domain feature is only available when the Domain

Switch is in use. This feature is not operational when a Serial

Adapter has been configured to Domain 8 from within the

software configuration menu or when the Domain Switch setting

has been overridden by the software configuration menu.

LED Indicators

There are three LEDs on the top panel of the RangeLAN2 791x

Serial Adapter:

❑ The Status LED on the right side (with the unit orien-

tated so that you can read the Proxim logo), changes

colors from yellow (initializing) to green (operational).

This LED blinks red in a repeating pattern when a

problem occurs with the unit. See Chapter 14 for a

further discussion of these patterns.

❑ The Radio LED in the center blinks yellow when the

Serial Adapter is transmitting data packets over its

radio.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 126 127

Sin comentarios

Proxim 7910 Guía de usuario Pagina 28